FANDOM


DescriptionEdit

Starting out at Oak Point Yard, run some trash empties out to Harlem Terminal and drop them off before hauling a loaded cut back.

ObjectivesEdit

  • CLIMB ABOARD: Sit in the Engineer's seat of the lead locomotive
  • TRAIN SETUP: Set the Reverser to FORWARD and sound the horn TWICE
  • STOP AT LOCATION: Harlem Terminal Entrance
  • STOP AT LOCATION: Track 1
  • UNCOUPLE VEHICLES: 15 Vehicles
  • WAIT: Wait for a moment
  • CLIMB ABOARD: Return to the Engineer's seat of the lead locomotive
  • STOP AT LOCATION: Yard Head Shunt
  • REVERSER: Set the Reverser to NEUTRAL
  • BRAKES: Set the Automatic Brake to HANDLE OFF
  • CUTOUT SWITCH: Set the Cutout Switch to CUTOUT
  • MULTIPLE UNIT VALVE: Set the MU-2A Valve to TRAIL 6
  • LIGHTS: Switch off any active lights on the locomotive
  • SWITCH OFF SYSTEMS: Switch off the Engine Run, Generator Field and Fuel Pump
  • HEADLIGHT CONTROL: Set the Headlights to be controlled from another unit
  • RADIO FUSE: Switch off the Radio Fuse
  • CHANGE CABS: Move to the Rear Locomotive cab for the return trip
  • RADIO: Switch on the Radio Fuse
  • HEADLIGHT CONTROL: Set the Headlights control to be coupled at the Long Hood end
  • SWITCH ON SYSTEMS: Switch on the Engine Run, Generator Field and Fuel Pump
  • LIGHTS: Activate Required Lights on the Locomotive
  • MULTIPLE UNIT VALVE: Set the MU-2A Valve to LEAD
  • CUTOUT SWITCH: Set the Cutout Switch to FREIGHT
  • INDEPENDENT BRAKE: Apply the Independent Brake to at least 30%
  • AUTOBRAKE: Set the Autobrake to RELEASE
  • BRAKE PRESSURE: Raise the BRAKE PIPE pressure to above 79PSI
  • REVERSER: Set the Reverser to FORWARD
  • STOP AT LOCATION: Harlem Terminal Entrance
  • COUPLE TO FORMATION: Trash Cars
  • WAIT: Wait for a moment
  • STOP AT LOCATION: Oak Point Entrance
  • STOP AT LOCATION: Track 5
  • DUTY COMPLETE: Climb down from the locomotive to complete this shift

Task LogEdit

  • Welcome to Oak Point Yard. Another transfer of waste cars is ready to go. Take them back to Harlem Terminal and bring out the next loaded cut for onward disposal.
  • Set the Track Switches to gain access to Track 1.
  • Check and Align any track switches in order to reach the Terminal entrance again for the return trip
  • Set the Track Switches again, this time to access the cars on Track 2.
  • Welcome back to Oak Point Yard. Place these cars on Track 5. Check for correct switch positions before entering.
NEC: New York
Locomotives ACS-64 - GP38-2
Rolling Stock Amfleet I - 50 foot Plate C Boxcar - 5201-Cubic Foot Covered Car - 30,500 Gallon Tank Car - 73-foot center-beam flatcar - 85-foot Open Deck Flatcar
Locations Newark Airport - Newark - New York Penn - Fresh Pond Yard - Oak Point Yard - New Rochelle
Operators Amtrak - CSX Transportation
Tutorials ACS-64 Introduction - GP38-2 YN3 Introduction
Scenarios City Sprinter - Terminal Switcher - City Lights - Back Track - Right Round - Trash Collector - New York Switcher
DLC CSX GP40-2